| Step | | Procedure & Parts & Tools |
| 1 |
|
PUSH IN ON THE 2 ORANGE TABS TO REMOVE THE BASE COVER.
|
| 2 |
|
REMOVE THE BASE COVER.
|
| 3 |
|
LOOSEN THE BRUSH HEIGHT KNOB AND REMOVE IT. SET IT ASIDE.
|
| 4 |
|
FLIP THE BASE OVER AND REMOVE THE 5 SCREWS.
| Screwdriver-phillips |
|
|
| 5 |
|
FLIP THE BASE BACK OVER AND REMOVE THE BRUSH MOTOR COVER.
|
| 6 |
|
SLIDE THE CONTROL BOARD UP OUT OF BASE. PULL TO REMOVE ALL THE WIRES ON BOARD. NOTE: KEEP NOTES ON WHAT WIRE GOES WHERE. THIS WILL MAKE IT EASIER WHEN INSTALLING THE NEW CONTROL BOARD. VISUALLY INSPECT THE WIRES. IF NECESSARY, CUT WIRE BACK 1/4 IN. AND CRIMP NEW WIRE CONNECTORS ON WIRE. REVERSE STEPS 1 THRU 6 TO REINSTALL THE CONTROL BOARD AND REASSEMBLE THE MACHINE.
|